Typ 0710 ist eine zweiteilige , einfach wirkende Stangendichtung , bestehend aus einem Profflring aus PTFE-Compound und einem O-Ring als Vorspannelement.
Großer Temperatureinsatzbereich und größte Medienbeständigkeit in Abhängigkeit der O-Ring-Werkstoffauswahl
Kleinster Reibungskoeffzient und dadurch keine Energieverluste
Geringe axiale Höhe
Betrieb
Wir empfehlen ein Montagwerkzeug. Das Montagewerkzeug sollte frei von scharfen Kanten und Graten sein. Zur Montage werden die Einzelteile mit dichtungsverträglichem Fett auf Mineralölbasis oder mit dem Medium des Systems gefettet oder geölt.
Optionen
Typ 0710 kann in Verbindung mit Doppelabstreifern eingesetzt werden. Typ 0710 können auf Wunsch aus temperatur- und medienbeständigen FKM/PTFE-Compounds hergestellt werden. Für Schwerhydraulikanwendungen sollten die Toleranzan auf H8/f8 geändert werden. Bitte kontaktieren Sie in diesem Fall unseren Kundenservice. Die Werte für den zulässigen Dichtspalt der Typ 0710-Stangendichtung entnehmen Sie bitte der Tabelle unten.
Tabellen
OPERATING CONDITIONS
MEDIA
Mineral oils (DIN 51524)
HFA and HFB
HFC
TEMPERATURE
from -30°C till +105°C
from +5°C till +60°C
from -30°C till +60°C
PRESSURE
max. 400 Bar
max. 400 Bar
max. 400 Bar
SPEED
max. 5.0 m/s
max. 5.0 m/s
max. 5.0 m/s
Note: The above data are maximum values and cannot be used at the same time.
SURFACE ROUGHNESS
Ra
Rmax
Sliding Surface
max. 0.2 µm
max. 2.0 µm
Groove Base
max. 1.6 µm
max. 6.3 µm
Groove Flanks
max. 3.2 µm
max. 15 µm
Note: It is recommended to have 50% to 90% of the working surface material contact area value.
PERMISSIBLE SEALING GAP
B (mm)
Smax (mm)
x
150 Bar
250 Bar
400 Bar
2.2
0.25
0.15
0.10
3.2
0.35
0.20
0.10
4.2
0.35
0.20
0.15
6.3
0.45
0.30
0.20
8.1
0.6
0.35
0.25
9.5
0.7
0.50
0.30
Note: The largest sealing gap value occurring on the non-pressurized side of the seal does have a vital importance for the function of the seal and in this respect it is quite important to use the S value lower than the above indicated numbers.